HIGH OUTPUT, LOW WEIGHT
The LS500 SubBass extends the usable range of the PS10 Loudspeaker to 38Hz, providing 134dB Peak output in an extremely compact, light weight package.
The PS10 TDcontroller's integral sub section and combined signal (PS10 and LS500) Speakon wiring ensure cost effective and simple system implementation. One LS500 is typically used with 2x PS10 loudspeakers. Additional units may be used for an enhanced effect.
PRODUCT FEATURES
High power system (134dB Peak SPL @ 1m) with 15" VLF driver
Extends VLF of PS10 Systems to 38Hz
Integral pole-mount that supports 1x or 2x PS10 Loudspeakers
Sophisticated control electronics ensure reliable, linear operation
SYSTEM SPECIFICATIONS LS500 with PS10 TD Controller
Frequency Response [a] 43 Hz - 110 Hz ±3dB
Usable Range @-6dB [a] 38 Hz - 120 Hz
Sensitivity 1W @ 1m [b] 101 dB SPL Nominal
Nominal Peak SPL @ 1m [b] 131 to 134 dB Peak (300 to 800 W RMS Amp.)
Crossover Frequencies 120 Hz Active through PS10TD
Nominal Impedance 4 Ohms
Recommended Amplifiers 300 to 800 Watts into 4 Ohms
SYSTEM OPERATION
Electronic Controller The LS500 Subwoofer must be used with a Nexo Controller (PS10 TD analogue, NX241 digital or
PS10AMP integrated power amplifier). Use without a properly connected Controller will result in poor
sound quality and may damage the components.
Subbass The LS500 Subwoofer provides optional VLF extension for PS10 Loudspeakers. Active two-way operation
with the PS10 is included in the PS10TD, NX241 or PS10AMP. One LS500 matches 2 x PS10, additional
LS500 may be used for enhanced effect.
Speaker Cables The PS10 is wired 2- & 2+ on Speakon connectors, LS500 on 1- & 1+. Loop through Speakons are
present on both products. Single identical cables can thus be used to loop through combinations of up
to 2 x PS10 & 1 x LS500 in no particular order.As part of a policy of continual improvement, NEXO
reserves the right to change specifications without notice.
PRODUCT FEATURES
Components : VLF 1 x 15" ( 38cm ) long excursion 4 Ohm driver
Height x Width x Depth 430 x 689 x 528 mm (16.88" x 27.13" x 20.75")
Weight 33 kg (73 lbs) net
Connectors 2 x NL4MP SPEAKON 4 pole
Construction Baltic Birch Ply & textured, polyurethane black coating
Fittings: Handles 2, integral to cabinet
Front finish Perforated steel grilles
Flying Points 3 steel anchor points for flying tracks on side and back
Stand fittings Internal Stand Fitting on Top (35mm, 1 3/8") accepts a mast supporting 1 or 2 PS10s.
.jpg)
